Skip to content

Can metal dome be soldered to printed circuit board?

by Andy on May 31st, 2010

Can metal dome be soldered to printed circuit board? We aren’t recommend. When metal dome are pushed, the feet actually move outward slightly. When soldered to circuit board, the feet of the domes are restricted from their natural movement. This restriction can negatively affect the tactile response of the domes, and in some cases, cause irreparable damage to metal dome or break the solder joint. so we aren’t recommend to solder theĀ snap dome on printed circuit board.

Related posts:

1. IQC For Metal Domes;

2. IQC for metal dome array;

3. The specifications of metal dome;

4. The specifications of dome array.

From → Dome Array

No comments yet

Leave a Reply

Note: XHTML is allowed. Your email address will never be published.

Subscribe to this comment feed via RSS