Skip to content

The difference of Laser Cutting and Mold to make the dome array

by admin on January 12th, 2009

Now, we have two ways to make the dome array: Laser Cutting and set up the mold. Do you know the difference of them? Ok, follow me.

                                                  Laser Cutting                     Set up Mold
1. the caused Fee                    With tooling Fee                  HIgh tooling fee
2. Tolerance                              +/-0.15mm                         +/-0.10mm
3. Production Capacity               50K/day                          200k/day

If your order quantity is too large and demands very strictly, we recommend to set up the tooling. And if your total fund reach to a certain amount, we will return back to you.  If not, Laser cutting to make the dome array is your best choice for production, I think. It’s very convenient.

If you need more information about dome array, please feel free to contact us or visit our FAQs.

From → Dome Array

No comments yet

Leave a Reply

Note: XHTML is allowed. Your email address will never be published.

Subscribe to this comment feed via RSS